CONCRETE PUMP 7 PLASTERING MACHINE-BUNKER S8 EV (1 PHASE)
Plastering – Conveying – Spraying – Injecting.
(Controls-Mains reverse , variable pump speed , pump direction reverse , compressor control & vibrator control.)
Its output regulation from 0 until the maximum value for low power consumption.
The biggest pumpable grain size of its category (10 mm).
From plaster to concrete up to 8 mm, from injections to transport
Its minimal dimensions and light weight allow an easy transport and on-site positioning.
Controls are all on a single waterproof control panel enabling an easy control of all the machine's functions.
Above all, the electric box is equipped of an important electronic device, the INVERTER allows output control but also reduces drastically power consumption when starting the machine.Thanks to the high grain size and the variable output rate, it is possible to pump, spray and inject:
Traditional plasters, both for indoors and outdoors
Pre-mixed plasters, both for indoors and outdoors
Special plasters
Fibre-reinforced mortars
Refractory mortars
Mortars for joint filling
Self-levelling floor screeds
Pre-packed mortar and special products for structural work on concrete and stone buildings
It's also possible to spray concrete on steel wire meshes for restoration works. Thanks to a practical kit, it is possible to carry out cement slurries injections at a controlled pressure. Using the appropriate spray gun, it's possible to fill joints or connections.
